Tena Control Lighting Kit for the 39 inch Seaview from Moebius Models (Complete Kit)

Tena Control Lighting Kit for the 39 inch Seaview from Moebius Models (Complete Kit)TenaControls SVWS A Lighting Kit for the 39 inch Seaview from Moebius Models (Complete Kit). Make your Seaview build more realistic with TenaControls microprocessor powered light kit. All the connections to these boards are made to the eight wire mating connectors, no soldering (to the control board). This board comes with pre wired power wires to run on 9 VDC or 12 VDC. This board when powered up will have all the lights off, swipe the supplied

TenaControls SVWS-A Lighting Kit for the 39-inch Seaview from Moebius Models (Complete Kit). Make your Seaview build more realistic with TenaControls microprocessor-powered light kit. All the connections to these boards are made to the eight-wire mating connectors, no soldering (to the control board). This board comes with pre-wired power wires to run on 9 VDC or 12 VDC. This board when powered up will have all the lights off, swipe the supplied magnet across the magnetic switch and all the lights come on, swipe again and the Navigation Lights go off, swipe again and the Tail Lights and Sail Fin Light go off, swipe again and the Flood Lights go off, swipe again and the Internal Cabin Lights go off placing the board in Demo Mode. In this mode all the above functions will repeat automatically every 5 to 6 seconds. To stop it just swipe the magnet and all the lights will go off and stay off. Includes: One (1) fully assembled board – just connect the LED’s. One (1) Magnetic Switch. One (1) Magnetic. One (1) Red 3mm LED. One (1) Green 3mm led. Three (3) White 1.8mm led’s. Four (4) White 5mm LED's. Two (2) White LED Strip Tape pre-wired. Miniature eight-wire JST connectors. Wiring and shrink tubing. Best warranty in the business – 5-Year Warranty -volt battery holder and micro On/Off slide switch, which turns the car light board on or off, to the board for your convenience. You just need to plug the eight-wire JST connector into the mating connector on the board and connect the LED to its corresponding wire coming from the eight-wire JST connector. The magnetic reed switch allows you to toggle through all the light modes, just by using the enclosed supplied magnet. This feature allows for the car to stay intact, with no holes for a momentary switch (on plastic model cars). What’s included: One (1) fully assembled board – just connect the LED. One (1) battery clip for 12 12-volt battery and a 12-volt battery., One (1) on/off switch wired to the board., One (1) magnetic reed switch. One (1) magnet. Shrink tubing. Red, Orange and White LEDS. Miniature eight-wire JST connector. Best warranty in the business – 5 Year Warranty (for warranty claims, the buyer should contact TenaControls directly). Model not included.